PLM Tech Talk Blog
In parts and assemblies, you can define coordinate systems by entering absolute numeric values for position and orientation. These values define the position relative to the local origin, and not the global origin.
To know how these numerical defined coordinate systems works follow below steps and videos.
Read more
Recently we posted “How to Shift Trim/Extend & Offset Work Plane on Sketch Creation | AUTODESK INVENTOR TIPS” and now we are sharing two new tips from our “120 Autodesk Inventor Tips” vault.
Our Autodesk Subject Matter Expert from i GET IT Learning created these 120 short tech tips to present at Autodesk University.
Read moreWe have discussed quite a bit about modeling and simulation in an integrated environment. However, our discussions have been on pre-processing side only. Lets discuss in this blog article how rich a designer based environment can be for visualizing and editing simulation results. Scenario Apps Enhancements Sequential Simulations: Restart enhancement: Earlier the read/write data was limited to the last increment
Read more
The Command Finder is now referred to as Search and can search for Commands, Customer Defaults, Preferences, Tips from the Discovery Center, and Check-Mate tests. Follow below steps to Know how use Search Enhancement – The Search Command is in the top right corner of the NX window and press Enter, NX displays search results in the following tabs in
Read more